Cape Town – The technology for vaccinating people against diseases is almost the same as it was 50 years ago – a freeze-dried powder vaccine that requires continuous refrigerated storage, liquid reconstitution before use, and a needle-and-syringe injection.
But thanks to researchers at Stanford University and the University of North Carolina at Chapel Hill, all that could change. They have produced a 3D printed vaccine patch which they claim provides greater protection than a typical vaccine shot.
Applied directly to the skin, the microneedle patch reportedly delivered an immune response 10 times greater than a vaccine delivered into an arm muscle via a needle jab.
The microneedle patch also has other advantages, including easy and painless delivery, and the potential to be self-administered.
The patches are typically formed of tiny 3D printed microneedles arranged on a polymer patch, and are applied directly to the skin. The microneedle prototype is a collection of dozens of tiny needles that are lined up on a small patch.
The needles are so tiny that each one is measured in micrometers and is as thin as a human hair.
The vaccine then targets the immune cells present in the skin and generates an antigen-specific antibody response.
Microneedle patches also deliver logistical advantages. Vaccines delivered via a needle typically require cold storage in fridges or freezers, and usually require a trip to a clinic, hospital or vaccination centre.
In contrast, vaccine-coated microneedle patches can be shipped anywhere in the world without special handling, and as they can be self-administered, would mean fewer trips to hospitals or clinics for patients.
The scientists believe that such benefits could potentially encourage higher vaccination rates in the future. Substantial research has been undertaken in leveraging 3D printing technologies to produce microneedle patches in previous years. 3D printing allows greater customisation and repeatability over traditional micromolding techniques, and enables the patches to be manufactured on demand.
This removes the need for storage space within clinics and laboratories while side-stepping the high initial tooling costs of micromolding methods.
In 2018, for instance, scientists at the University of Texas in Dallas developed a new low-cost method of making microneedle arrays using an FFF 3D printer, while earlier this year researchers from Rutgers University used a projection micro-stereolithography technique to create 4D printed bio-inspired and programmable microneedles that enhance tissue adhesion.
Elsewhere, scientists from Arizona State University and the University of Southern California teamed up to produce 3D printed microneedle patches inspired by limpets, which could be used to deliver drugs painlessly to patients in the future.
Most recently, a novel device that combines 3D printing, microneedles, and microelectromechanical systems was produced by the University of Kent and the University of Strathclyde, which could be leveraged to provide controllable transdermal drug delivery.
wesley@fastcompany.co.za.
IOL TECH